ralf_koenig61
Almera ABS and Steering Issues
Summary of the thread
A 2001 Nissan Almera diesel exhibited issues with the tire pressure light, intermittent ABS light, and vibrating steering, particularly at higher speeds. These symptoms suggested a tire problem, potentially due to uneven pressure affecting the ABS sensors and power steering. A faulty valve causing a slow leak was identified as the root cause. Replacing the valve and rebalancing the tires resolved the issues, ensuring safe driving.
Did this summary help you solve your problem?
4 comment(s)
ralf_koenig61 (community.author)
I haven't checked with a gauge yet, just looked at them and didn't see anything obvious. Could a bad valve cause this, even without a visible flat?
erwin_eis1
Yes, a bad valve could definitely be the problem. A slow leak from a faulty valve would gradually lower the tire pressure, triggering the warning light and affecting the ABS and steering as the pressure drops. However, to be sure and not miss anything, I'd recommend a workshop visit for a thorough check and repair. It's crucial to get it fixed properly for safety.
ralf_koenig61 (community.author)
Thanks for the advice. I took it to a workshop, and it was a defective valve in one of the tires, leaking slowly. They replaced the valve and rebalanced all the tires. Cost me 280€, but at least it's safe to drive now.
rmh_community_comment_box_header
community_crosslink_scanner_headline
community_crosslink_scanner_intro
community_crosslink_scanner_title
community_crosslink_scanner_price
community_crosslink_rmh_headline
community_crosslink_rmh_intro
community_crosslink_rmh_title
community_crosslink_rmh_subtitle
community_crosslink_rmh_brand
NISSAN
community_crosslink_rmh_model
ALMERA
erwin_eis1
Based on those symptoms, especially the tire pressure warning with the ABS and power steering issues, it really points to a tire problem. A big pressure drop in one tire can mess with the ABS sensors and strain the power steering because of uneven rolling. Have you checked the tires for damage or used a gauge to check the pressures? What are the readings?