Goemon

Persistent Headlamp Leveler Error After Sensor Replacement

I recently replaced the headlamp leveler sensor on my Audi A4, but I'm still getting an error message every time I start the ignition. Has anyone experienced a similar issue? Could there be another underlying problem causing this error, or is there a specific reset procedure I should follow after installing a new sensor? Any advice would be greatly appreciated!

After replacing the headlamp leveler sensor on an Audi A4, an error message persists upon ignition. Possible causes include a loose connection or the need for a system reset. Suggested solutions involve ensuring the sensor is properly connected and attempting a battery disconnect to reset the system.

Did this summary help you solve your problem?

1 comment(s)

Check if the sensor is properly connected and seated. Sometimes, a loose connection can cause error messages. If everything seems fine, try disconnecting the battery for a few minutes to reset the system. Let me know if this resolves the issue or if you need further assistance.

rmh_community_comment_box_header

community_crosslink_scanner_headline

community_crosslink_scanner_intro

community_crosslink_scanner_title

community_crosslink_scanner_price

community_crosslink_rmh_headline

community_crosslink_rmh_intro

community_crosslink_rmh_title

community_crosslink_rmh_subtitle

community_crosslink_rmh_brand

AUDI

community_crosslink_rmh_model