100% Free

No Scanner Needed

Carly logo

Carly Community

OMannRider

Peugeot 807 automatic gearbox issues

Experiencing issues with my 2004 Peugeot 807 gasoline's automatic gearbox. At 275414 km, shifting isn't possible via the paddle shifters, the gearbox seems to be slipping, leading to unclean shifts, and there's an awful grinding noise when it shifts. The paddle shifters are unresponsive, and the gearbox has gone into emergency mode. There's an error stored. Could this be a defective transmission control unit? Anyone else faced something similar?

4 comment(s)

patricianacht10

Sounds like you're having a time! I had something similar happen with my 807. Gearbox acting strange, eh? Emergency mode is no fun. Paddle shifters not playing ball...yup, rings a bell. Did you notice any specific conditions when it started, like after a long drive or during cold weather? What kind of error code did you pull from the memory? Just curious to see if it matches what I was getting.

OMannRider (Author)

It seemed to start gradually, without any obvious trigger like a long drive or cold weather. One day it was fine, the next, it was like the gearbox had a mind of its own! As for the specific error code, I'd have to check again, but from what I recall, it pointed towards a fault in the transmission control module. Did yours also point towards the control module being the culprit?

patricianacht10

Sounds eerily similar to what I went through. Honestly, after all the messing about and checking, it did point straight back to the control unit. Get it checked out by a decent workshop. They'll be able to confirm it properly, but from the sounds of it, you're probably looking at a new or refurbished control module. Cost me around 1000€ all in, but it sorted the issue right out. Better than writing the car off, eh?

OMannRider (Author)

Thanks for sharing your experience! It's a relief to know I'm not alone, and your insights have been incredibly helpful. I'll book it into a reputable workshop and have them take a look at the control module. Hopefully, a replacement will do the trick. I appreciate you taking the time to share your wisdom!

Join the discussion now: