Back
LutzRacer
Navigationssystem is not working
(Translated from German)
4 comment(s)
Hey, sure, I can tell you! The repair cost me a total of €165. It turned out that the cable connection between the control unit and the display was defective - there was probably a bad connection. Since I've been to the mechanic, the navigation unit has been working again without any problems. Apart from that, I haven't had any other problems. I hope it works just as smoothly for you! Best regards Marco
(Translated from German)
Hey Marco, thanks for the info! 165 actually sounds fair if the problem is fixed afterwards. I'll probably make an appointment with a garage and hope that they can fix it as well as you did. But before that, I'll do a bit of research to find a good garage. Maybe I'll go to one that specializes in Skodas first. Thanks again and best regards
(Translated from German)
Hey, I had the same problem with my 2016 Skoda Superb. The screen kept failing and it turned out that the cable connection between the control unit and the display had a bad connection. This was a serious problem because it affected the whole navigation and infotainment. At the workshop, they checked the affected cables and reconnected them. It took a while, but afterwards everything worked perfectly again. Such problems can occur with older cable connections, especially if the car has a lot of miles on it. Hope this helps you! Greetings Marco
(Translated from German)