vivienfuchs1
WRV System Readiness Incomplete
Summary of the thread
The issue with the 2018 Honda WRV was an incomplete system readiness check, indicated by an error message on the speedometer. This occurred after using an OBD2 reader to clear historical fault codes. Clearing these codes reset the system readiness monitors, requiring the vehicle to complete specific drive cycles to reset them. After driving approximately 50 km, the system readiness checks were completed, resolving the issue without any repair costs.
Did this summary help you solve your problem?
4 comment(s)
vivienfuchs1 (community.author)
Thank you for your prompt response. I utilized the OBD2 reader to assess the general health of the vehicle and cleared some historical fault codes that appeared inconsequential at the time. Could this clearing of codes be the direct cause of the incomplete system readiness, and if so, what would you advise?
joseph_scholz1
Yep, clearing those codes is almost certainly the reason. The system readiness monitors reset when you do that. The car needs to run through specific drive cycles to reset them, and sometimes it takes a while. It should eventually clear itself, but if you need an emissions test soon, you might want to take it to a workshop. They have tools to force the monitors to run.
vivienfuchs1 (community.author)
I appreciate your insights immensely. I understand now that clearing the codes initiated this situation. I will monitor the system and, if necessary, consult a workshop as you suggested. However, after driving approximately 50km, the error message disappeared from the speedometer. Further inspection via OBD2 revealed that all system readiness checks are now complete. The repair cost was 0€. Thank you again for your invaluable assistance.
rmh_community_comment_box_header
community_crosslink_scanner_headline
community_crosslink_scanner_intro
community_crosslink_scanner_title
community_crosslink_scanner_price
community_crosslink_rmh_headline
community_crosslink_rmh_intro
community_crosslink_rmh_title
community_crosslink_rmh_subtitle
community_crosslink_rmh_brand
HONDA
community_crosslink_rmh_model
WRV
joseph_scholz1
Sounds like your car's computer hasn't completed all its self-tests since the OBD2 reading. These 'readiness monitors' check things like the exhaust system to ensure it's within acceptable emissions limits. What exactly did you read out with the OBD2? Did you clear any codes?