100% Free

No Scanner Needed

Carly logo
Prices

ReinMueller

Electronics problems with the 2018 BMW 2 Series petrol engine: sat nav failure and warning lights

Hello everyone, I have a few problems with my 2018 BMW 2 Series gasoline engine, which now has 27790 km on it. The electronics have recently started to go haywire, my sat nav sometimes won't start at all or only after a while. And sometimes a warning light comes on in the speedometer. Have any of you had similar problems and can tell me how they were solved by your mechanic? My last visit to the garage wasn't that great, so I'd better ask here before I go there again. Thanks in advance!

(Translated from German)

Summary of the thread

The conversation revolves around a 2018 BMW 2 Series petrol engine experiencing electronic issues, including a malfunctioning sat nav and warning lights on the speedometer. Possible causes suggested include faulty communication between control units, problems in the vehicle electrical system, and voltage fluctuations in the battery. Solutions proposed range from extensive troubleshooting and repair at a factory, to a simple reset of the control units by disconnecting the battery. A software update was also suggested as a potential fix for the sat nav issue.

Did this summary help you solve your problem?

201 comment(s)

CarlyMechanic

community_quotation:

community_author_wrote_on

The gearbox display flickers when starting, sometimes it jerks when accelerating and then the display in the instrument cluster also flickers. Transmission goes into emergency program from time to time. Transmission oil change with filter was carried out properly but no improvement.

The issue you're describing could be due to a faulty transmission control module or a problem with the wiring. I would recommend starting with checking the transmission control module and its connections. If the problem persists, you may need to have a mechanic inspect the wiring and possibly the transmission itself. Please keep us updated on your progress.

EduyMayka

All the lights on the dashboard turn on and off, the needles go crazy and the windshield wipers turn on by themselves,

(community_translated_from_language)

CarlyMechanic

community_quotation:

community_author_wrote_on

All the lights on the dashboard turn on and off, the needles go crazy and the windshield wipers turn on by themselves,

This could be due to a problem with the vehicle's electrical system, such as a faulty ignition switch or a problem with the wiring. I would recommend starting with checking the ignition switch and the fuses. If the problem persists, you may need to have a mechanic inspect the wiring. Please keep us updated on your progress.

Linndy

Hello, I have these problems with my car BMW E65 745i 2002 00274E 002747 002749 002748 00272C 00272D 00272A 00272B What should I do?

CarlyMechanic

community_quotation:

community_author_wrote_on

Hello, I have these problems with my car BMW E65 745i 2002 00274E 002747 002749 002748 00272C 00272D 00272A 00272B What should I do?

These error codes seem to be related to the engine control module and the fuel system. I would recommend starting with checking the fuel pump, fuel filter, and fuel injectors. If the problem persists, you may need to have a mechanic inspect the engine control module and its connections. Please keep us updated on your progress.

Hakan

community_quotation:

community_author_wrote_on

Hello what exactly could it be...my lower holding apple has failed, unfortunately I can neither switch the massage function on the seat nor the parktronic or even the dtc on and off...!

Unfortunately, the problem still persists after the battery has been reinstalled. Fuses all blown in the trunk and passenger footwell.... All cables and connections also checked even new switch panels installed unfortunately still the problem.... It is reported that the ihka power supply has a message with error code 009c70 And the electric heater with error code 009c55 as a message.

(community_translated_from_language)

CarlyMechanic

community_quotation:

community_author_wrote_on

Unfortunately, the problem still persists after the battery has been reinstalled. Fuses all blown in the trunk and passenger footwell.... All cables and connections also checked even new switch panels installed unfortunately still the problem.... It is reported that the ihka power supply has a message with error code 009c70 And the electric heater with error code 009c55 as a message.

The error codes you're seeing typically indicate a problem with the power supply to the IHKA (Integrated Automatic Heating/Air Conditioning System) and the electric heater. This could be due to a faulty control module or a wiring issue. I would recommend having a mechanic inspect the control module and wiring. Please keep us updated on your progress.

Trock

My abs and brake light won't go off

CarlyMechanic

community_quotation:

community_author_wrote_on

My abs and brake light won't go off

This could be due to a number of issues such as a faulty ABS sensor, low brake fluid, or a problem with the brake system. I would recommend starting with checking the ABS sensors and the brake fluid level. If the problem persists, you may need to have a mechanic inspect the brake system. Please keep us updated on your progress.

Örni94

Moin, I have read out my car and there are 4 error messages: ABS: D354 Message missing. D355 Message missing. D356 Message missing. EPS D514 Message error engine running Perhaps you can help me with this.

(community_translated_from_language)

rmh_community_comment_box_header

community_crosslink_scanner_headline

community_crosslink_scanner_intro

community_crosslink_scanner_title

community_crosslink_scanner_price

community_crosslink_rmh_headline

community_crosslink_rmh_intro

community_crosslink_rmh_title

community_crosslink_rmh_subtitle

community_crosslink_rmh_brand

BMW

community_crosslink_rmh_model

2