ReinMueller

Electronics problems with the 2018 BMW 2 Series petrol engine: sat nav failure and warning lights

Hello everyone, I have a few problems with my 2018 BMW 2 Series gasoline engine, which now has 27790 km on it. The electronics have recently started to go haywire, my sat nav sometimes won't start at all or only after a while. And sometimes a warning light comes on in the speedometer. Have any of you had similar problems and can tell me how they were solved by your mechanic? My last visit to the garage wasn't that great, so I'd better ask here before I go there again. Thanks in advance!

(Translated from German)

201 comment(s)

Quotation:
@1304dominik wrote on
Hi, I had similar problems with a 2007 BMW 3 Series (E91). In my case, the problem was solved by restarting the control units (disconnecting the battery for a minute)!

Thanks, thanks to this tip I was able to save my sat nav, which was constantly stuck. Could it be that my battery is getting old and should be replaced?

(Translated from German)

Quotation:
@Racer2024 wrote on
Thanks, thanks to this tip I was able to save my sat nav, which was constantly stuck. Could it be that my battery is getting old and should be replaced?

Great, with pleasure! The voltage is fine for me, I haven't replaced the battery yet and the problem hasn't returned.

(Translated from German)

I need the features of the BMW E46 1999 instrument panel programming when I change the instrument panel and Yanki parking

Quotation:
@1304dominik wrote on
Great, with pleasure! The voltage is fine for me, I haven't replaced the battery yet and the problem hasn't returned.

Super! Then I hope it stays that way. Always good to get helpful advice :-)

(Translated from German)

Quotation:
@Bimmer wrote on
I need the features of the BMW E46 1999 instrument panel programming when I change the instrument panel and Yanki parking

Unfortunately, we cannot offer you this function.

(Translated from German)

I own a Mercedes e300 hybrid I pulled up and went to get lunch came back to the car and now I have a presafe error and no traction control the Carly finds the issue but will not clear the fault

I have no issue with the scanner, just sometimes it doesn't clear codes with engine running, but doing for a couple of times it erases otherwise everything is ok!

Quotation:
@Naterutter wrote on
I own a Mercedes e300 hybrid I pulled up and went to get lunch came back to the car and now I have a presafe error and no traction control the Carly finds the issue but will not clear the fault

Hello, Is it possible that the error code is currently present, i.e. static? If so, it may well be that the error code cannot be deleted until the error has been rectified.

(Translated from German)

Quotation:
@Brandon wrote on
I have no issue with the scanner, just sometimes it doesn't clear codes with engine running, but doing for a couple of times it erases otherwise everything is ok!

Hello Brandon, Thank you for your feedback. As a rule, it is always better to keep the engine running during the readout process to ensure a stable power supply. Sometimes it can indeed happen that the error code can only be deleted the second time. However, if this happens more often in the future, please contact us again so that we can take a closer look ;) Regards

(Translated from German)

I have already replaced the sensor but it still shows me the error

(Translated from German)

Join the discussion now: