ReiBehrens
Fiorino NOx Sensor Connector Corrosion
Summary of the thread
A 2003 Fiat Fiorino was experiencing issues with the check engine light and exhaust fumes, suspected to be related to a NOx sensor problem. The likely cause was identified as corrosion in the sensor's connector, a common issue due to exposure to road salt and water. The suggested solution was to inspect and clean the connectors, which ultimately resolved the problem after a workshop confirmed and repaired the corroded connection.
Did this summary help you solve your problem?
4 comment(s)
ReiBehrens (community.author)
Good call about the connectors! I wiggled them, but didn't look closely. Where should I be looking? Is there a common spot where the wires break or the plug gets gunked up?
martinheld1
Dig deeper. On mine, the connector where it plugs into the sensor was the problem. Salt and water spray from the road caused corrosion. I tried cleaning it, but it was too far gone. If you're not comfortable doing it yourself, take it to a workshop, but I think that might be it.
ReiBehrens (community.author)
You were right! The workshop confirmed it was a corroded connector. They cleaned it, replaced some wire, and cleared the code. Total cost was 95€. Thanks for the advice; you saved me money and stress!
rmh_community_comment_box_header
community_crosslink_scanner_headline
community_crosslink_scanner_intro
community_crosslink_scanner_title
community_crosslink_scanner_price
community_crosslink_rmh_headline
community_crosslink_rmh_intro
community_crosslink_rmh_title
community_crosslink_rmh_subtitle
community_crosslink_rmh_brand
FIAT
community_crosslink_rmh_model
FIORINO
martinheld1
Sounds rough! I had a similar issue with my Fiorino – exhaust leak, engine light, the works. NOx sensor problems can be a pain. Before you buy a new sensor, have you checked the wiring and connectors? They're exposed and corrode easily. It's like a bad light switch – sometimes it's the switch, sometimes it's a loose wire.