jonathanschroeder1
GLE Driving Mode Error and Warning Signals
4 comment(s)
jonathanschroeder1 (Author)
Thanks for the response. When you had similar issues, did your scan tool point to specific error codes, or was it a more general communication fault? I want to make sure I'm not missing anything obvious before I dig deeper. Which connections did you check?
ottodunkel83
Honestly, I cannot recall the exact error codes. It was some time ago. But, yes, it presented as a general communication issue. I suggest taking it to a workshop. It will save you a lot of time.
jonathanschroeder1 (Author)
Thanks for your input. I had the cable connections of the control unit inspected at a trusted workshop. A defective connection to the BUS system was identified. The repair cost was 155€. The warning signal is now gone. Thank you again for pointing me in the right direction.
Join the discussion now:
ottodunkel83
I have a GLE too, and I had similar problems a while back. I kept getting random warning signals and my control module seemed to be acting up. Have you checked the connections thoroughly?