100% Free

No Scanner Needed

Carly logo
Prices

KleinFelix

Honda Fit knock sensor issue

My 2005 Honda Fit with a gasoline engine is acting up. The check engine light is on, fuel consumption is terrible, and the engine's idling roughly at 212036 km. I'm guessing it's the knock sensor, maybe a bad wire or connector? Has anyone seen this? I read the knock sensor helps the ECU determine ignition timing, and if it fails, the car runs poorly.

Summary of the thread

A 2005 Honda Fit is experiencing issues such as a check engine light, poor fuel consumption, and rough idling, leading to a suspicion of a faulty knock sensor. The knock sensor is crucial for determining ignition timing, and its failure can cause poor engine performance. The problem was identified as a corroded connector on the knock sensor, which was resolved by cleaning and replacing the sensor, resulting in improved engine performance.

Did this summary help you solve your problem?

4 comment(s)

matthiassilber58

I had a similar issue with my old Opel Corsa – check engine light, rough idle, the whole deal. It turned out to be a corroded connector on one of the sensors. You mention a bad wire or connector – have you looked closely at the knock sensor's wiring harness and the connector itself? Maybe wiggle it and see if anything changes? It might be a simple fix.

KleinFelix (community.author)

I took a peek, but it's cramped. The wires looked okay, but the connector... it's hard to get a good look. What should I be looking for on the connector? Any signs of corrosion or damage?

matthiassilber58

On my Corsa, the corrosion was obvious – greenish/white powdery stuff on the metal contacts inside the connector. Also, the plastic housing of the connector was cracked. Given your symptoms and suspicion of the knock sensor, it's worth a proper inspection. Maybe visit a workshop and let them look; they'll be able to diagnose it and replace the sensor and wiring if needed. Safer than messing with it yourself if you're not 100% sure.

KleinFelix (community.author)

I appreciate the help. I dropped it off at the workshop, and you were right. It was the knock sensor – the connector was corroded. They cleaned it and replaced the sensor. Cost me about 95€. Runs great now!

rmh_community_comment_box_header

community_crosslink_scanner_headline

community_crosslink_scanner_intro

community_crosslink_scanner_title

community_crosslink_scanner_price

community_crosslink_rmh_headline

community_crosslink_rmh_intro

community_crosslink_rmh_title

community_crosslink_rmh_subtitle

community_crosslink_rmh_brand

HONDA

community_crosslink_rmh_model

FIT