100% Free

No Scanner Needed

Carly logo

AndiAlbrecht86

BMW X1 2016 problems with the exhaust gas recirculation or EGR valve

Hello everyone, my BMW X1 (diesel, built in 2016) is causing problems: Check Engine light on, engine stops by itself, loss of power, bumpy engine, strong exhaust smell and engine jerks when idling. I suspect a problem with the EGR valve. Has anyone had similar experiences and how was this solved in the workshop? Are there any specific troubleshooting tips? Thank you very much!

(Translated from German)

45 comment(s)

Charles

Hello I have a bmw 525d e39 my problem is that the heating and air conditioning controls in the passenger compartment do not work and when I drive hot air escapes from the pedals and feet on the passenger side so what is my problem? Thanks in advance

(Translated from French)

CarlyMechanic

Quotation:

@Charles wrote on

Hello I have a bmw 525d e39 my problem is that the heating and air conditioning controls in the passenger compartment do not work and when I drive hot air escapes from the pedals and feet on the passenger side so what is my problem? Thanks in advance

It sounds like you might have an issue with your HVAC (Heating, Ventilation, and Air Conditioning) system. It could be a faulty control module, a stuck blend door, or a problem with the blower motor. I would recommend starting with checking the fuses and relays related to the HVAC system. If those are fine, you might need to have the HVAC control module checked for any faults. If the issue persists, it's best to have a mechanic inspect the system for any other potential issues.

oldie

Hello, on my E91 330xd with 288,000 km I get the error message 41E2 in Carly. As far as I understand it, I should clean the EGR valve. Unfortunately, the EGR valve is not accessible due to the throttle valve installed in front of it and the screws are partially covered. I will probably have to remove the intake manifold in order to clean the EGR valve. Or is there another possibility? Many thanks for your help

(Translated from German)

Mijan

My bmw code 004cae Description: DDE: Exhaust-gas recirculation controller, position sensor, signal what can I do to solve this and is it dangerous to drive

CarlyAdminBenny

Quotation:

@Mijan wrote on

My bmw code 004cae Description: DDE: Exhaust-gas recirculation controller, position sensor, signal what can I do to solve this and is it dangerous to drive

Hello, as a rule, the position sensor of the EGR valve is also installed in the EGR valve itself. Normally, the EGR valve should be replaced if this fault occurs. You can try removing the EGR valve and cleaning it, in some cases this can help to rectify the fault. However, the better option would be to replace the EGR valve.

(Translated from German)

Faxendicke

Error 000006 Mrs Side airbag Lamp lights up, door panel was off, nothing else done, cable is connected to the airbag

(Translated from German)

CarlyAdminBenny

Quotation:

@Faxendicke wrote on

Error 000006 Mrs Side airbag Lamp lights up, door panel was off, nothing else done, cable is connected to the airbag

Hello, was the airbag unplugged during this time and the ignition of the vehicle was accidentally switched on? Have you ever tried to delete the error or can the error not be deleted?

(Translated from German)

Vince

004C9E+ 0040E9 Good evening I have a 320 d e90 with 423000km and I have these two errors displayed on Carly! Can you help me?

(Translated from French)

CarlyAdminBenny

Quotation:

@Vince wrote on

004C9E+ 0040E9 Good evening I have a 320 d e90 with 423000km and I have these two errors displayed on Carly! Can you help me?

Hello Vince, According to your error codes, it looks like the EGR valve is defective. This defect is very common with this engine or this model. My recommendation would be to replace the EGR valve. Kind regards

(Translated from German)

IgorBMW

BMW 530d e61 LCI 4501 Exhaust gas recirculation control deviation New parts; pressure transducer Solenoid valve EGR valve Throttle valve Mass air flow sensor Vacuum system is tight Brake booster is tight Same error still there

(Translated from German)

Join the discussion now: