GabiKraus
Problems with 2014 BMW 4 Series gasoline engine: engine light, rough running, high consumption - throttle valve defective?
(Translated from German)
75 comment(s)
Mohamad
I have a BMW F10 520d 2014 facelift. I have had errors 278A00 and 244C00 for days. These are errors for the throttle valve and turbocharger. Now the question is whether there is a connection and whether there are repair procedures
(Translated from German)
CarlyAdminBenny
Quotation:
@Mohamad wrote on
I have a BMW F10 520d 2014 facelift. I have had errors 278A00 and 244C00 for days. These are errors for the throttle valve and turbocharger. Now the question is whether there is a connection and whether there are repair procedures
Hello, Yes, these faults could be related. If the throttle valve is no longer working properly, it could be that the boost pressure is too low as a result, causing this error. My recommendation would be to check the throttle valve more closely in order to diagnose a possible defect.
(Translated from German)
Clayton
Could this be from installing a new throttle body and spacer? If so, how do I get my e c u to learn the new installation
CarlyAdminBenny
Quotation:
@Clayton wrote on
Could this be from installing a new throttle body and spacer? If so, how do I get my e c u to learn the new installation
Hello, If a new throttle valve is installed, it usually needs to be tuned. However, the teach-in process is different for every car and every brand, which is why I cannot give you any precise information here.
(Translated from German)
Raptor1215
Hello bmw 330D touring 2012 Error DDE throttle button actuator
(Translated from German)
CarlyAdminBenny
Quotation:
@Raptor1215 wrote on
Hello bmw 330D touring 2012 Error DDE throttle button actuator
Hello, What repairs have already been carried out? The first step should be to test the wiring of the throttle valve, if everything is OK then the throttle valve should be replaced.
(Translated from German)
AlanYoung
Had the P0366 error which was saying immobilizer error.....I changed the throttle body and the car works perfectly again.
Sissou93
My vehicle is still immobilized following a code displayed P1604 on my Toyota yaris2 phase2 diesel, year 2010, odometer reading 152340km. The engine won't start, the starter works fine. Please let me know if there is a solution to my problem. Thank you in advance.
(Translated from French)
CarlyMechanic
Quotation:
@Sissou93 wrote on
My vehicle is still immobilized following a code displayed P1604 on my Toyota yaris2 phase2 diesel, year 2010, odometer reading 152340km. The engine won't start, the starter works fine. Please let me know if there is a solution to my problem. Thank you in advance.
Hello, The P1604 code is related to the startability of the vehicle, it's not directly related to the throttle body. It could be due to a weak battery, a problem with the fuel system, or an issue with the immobilizer system itself. I would recommend starting with a check of the battery and the fuel system. If these are fine, you may need to have the immobilizer system checked by a professional. Please keep us updated on your progress.
Join the discussion now:
BMWMarc
Hello everyone, unfortunately in my case it is not the throttle valve but the CCG that is causing the fault due to a defective clutch. As the clutch grinds, it needs more revs and other sensors are already spinning. Unfortunately, I only discovered this after replacing the mass air flow sensor, the throttle valves and the extenter shaft.
(Translated from German)